Mengaktifkan Remote SSh pada switch CISCO

Switch>ena
Switch#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#vlan 10
Switch(config-vlan)#name ssh
Switch(config-vlan)#exit
Switch(config)#inter
Switch(config)#interface vlan 10
Switch(config-if)#
%LINK-5-CHANGED: Interface Vlan10, changed state to up

Switch(config-if)#ip add
Switch(config-if)#ip address 192.168.1.100 255.255.255.0
Switch(config-if)#no shut
Switch(config-if)#int fa0/1
Switch(config-if)#sw
Switch(config-if)#switchport acc
Switch(config-if)#switchport access vlan 10
Switch(config-if)#no shut
Switch(config-if)#exit
Switch(config)#line vty 0
Switch(config-line)#pass
Switch(config-line)#password 123
Switch(config-line)#login
Switch(config-line)#exit
Switch(config)#host
Switch(config)#hostname switchcisco
switchcisco(config)#ip dom
switchcisco(config)#ip doma
switchcisco(config)#ip domain-n
switchcisco(config)#ip domain-name cisco
switchcisco(config)#cry
switchcisco(config)#crypto key
switchcisco(config)#crypto key gener
switchcisco(config)#crypto key generate rsa
The name for the keys will be: switchcisco.cisco
Choose the size of the key modulus in the range of 360 to 2048 for your
  General Purpose Keys. Choosing a key modulus greater than 512 may take
  a few minutes.

How many bits in the modulus [512]: 1024
% Generating 1024 bit RSA keys, keys will be non-exportable...[OK]

switchcisco(config)#user
*Mar 1 0:5:21.370:  %SSH-5-ENABLED: SSH 1.99 has been enabled
switchcisco(config)#username admin pass
switchcisco(config)#username admin password 123
switchcisco(config)#line vty 0
switchcisco(config-line)#login local
switchcisco(config-line)#tra
switchcisco(config-line)#transport inp
switchcisco(config-line)#transport input ssh
switchcisco(config-line)#exit
switchcisco(config)#ena
switchcisco(config)#enable pass
switchcisco(config)#enable password 321
switchcisco(config)#